Speed limit
You can enter a speed, and a Check Control message will indicate when you reach this speed. This enables you, for example, to receive warnings if you exceed a speed limit in an urban area.
You are only warned of reaching this speed a second time if your vehicle speed falls below it again by at least 5 km/h.
Displaying, setting or changing the limit
1. "Settings"
2. "Speed"
3. "Warning at:"
4. Turn the controller until the desired speed is displayed.
5. Press the controller. The speed limit is stored.
Applying your current speed as the limit
1. "Settings"
2. "Speed"
3. "Select current speed"
The system adopts your current speed as the limit.
Activating/deactivating the limit1. "Settings"
2. "Speed"
3. "Warning"
4. Press the controller.
See also:
Malfunction
The warning lamp
lights up yellow and
a message is shown on the Control
Display. The active steering is defective
or has been temporarily deactivated.
At low speeds, greater steering wheel
...
Rear seat heating
Switching on
Press the button once for each
temperature
level.
The maximum temperature is reached when
three LEDs are lit.
Switching off
Press the button longer.
The LEDs go out.
Temper ...
Using voice activation
Activating the voice activation system
1. Press the button on the
steering
wheel.
2. Wait for the signal.
3. Say the command.
The command is displayed in the instrument
cluster.
This symb ...