Checking the address as a destination

An address that is to be used for destination guidance must match the navigation data contained in the vehicle. The address can be checked for this purpose.

1. Select the desired contact and highlight the address.
2. Open "Options".
3. "Check as destination"
4. Correct and store the address if necessary.

    See also:

    Switching on/off
    Press the button. On: the LED lights up. Off: the LED goes out. The system can issue warnings at speeds above approx. 30 mph/50 km/h. The state is stored for the remote control currentl ...

    Your individual vehicle
    You have decided in favor of a vehicle with individualized equipment and features. This Owner's Manual describes the entire array of options and equipment available for a specific model. As a ...

    Programming
    LED, arrow 1. Memory buttons, arrow 2. Fixed-code hand-held transmitters 1. Switch on the ignition. 2. Initial setup: Press both outer buttons 1 and 3 for approx. 20 seconds until the L ...