Resetting the system

Reset the system after each correction of the tire inflation pressure and after every tire or wheel change.

1. "Vehicle Info"
2. "Vehicle status"
3. 4. Start the engine - do not drive away. "Reset"
4. Start the engine - do not drive away.
5. Reset the tire pressure using "Reset".
6. Drive away.

The tires are shown in gray and "Resetting TPM..." is displayed.

After driving for a few minutes, the set tire inflation pressures are applied as set values. The resetting process is completed automatically during driving. The tires are shown in green and "TPM active" is shown on the Control Display.

The trip can be interrupted at any time. If you drive away again, the process resumes automatically.

If a flat tire is detected during a reset, all tires are displayed in yellow.

    See also:

    General information
    Whether or not text messages and e-mails from the mobile phone are displayed depends on whether transmission from the mobile phone to the vehicle is supported. Text messages and emails may not ...

    General information
    Danger of pinching Monitor the closing process and make sure that the closing path of the glass sunroof is clear; otherwise, injuries may result.◀ Take the remote control with you Tak ...

    Operating principle
    With the ignition at radio readiness or beyond, , the following message is displayed on the Control Display: To hide the message: Press the controller. The main menu is displayed. The message i ...