Functional requirements
The system must have been initialized when the tire inflation pressure was correct; otherwise, reliable signaling of a flat tire is not ensured. Initialize the system after each correction of the tire inflation pressure and after every tire or wheel change.
See also:
Heated seats
Press the button once per temperature level. Three LEDs indicate the highest
temperature.
To switch off:
Press button longer.
If you continue driving within approx. the next 15 minutes, the sea ...
Measurement
Measurements are made by ultrasound sensors
in the bumpers.
The range is approx. 6 ft/2 m.
An acoustic warning is first given:
By the front* sensors and the two rear corner
sensors at appro ...
Low beams
Switch position with
the ignition switched
on: the low beams light up. ...