Preparation

1. Check whether the battery of the other vehicle has a voltage of 12 volts. This information can be found on the battery.

2. Switch off the engine of the assisting vehicle.

3. Switch off any electronic systems/power consumers in both vehicles.

Make sure that there is no contact between Bodywork contact between vehicles

Make sure that there is no contact between the bodywork of the two vehicles; otherwise, there is the danger of short circuits.

    See also:

    Signal tones
    When approaching an object, an intermittent tone is sounded that indicates the position of the object. For example, if an object is detected to the left rear of the vehicle, a signal tone sounds ...

    Opening/closing the glass sunroof
    With the sliding visor open, proceed as described under Sliding visor. ...

    The concept
    > The voice activation system can be used to control functions by spoken commands. > Functions that can only used when the vehicle is stopped cannot be operated using the voice activation sys ...