Incoming call

Receiving calls

If the number of the caller is stored in the phone book and is transmitted by the network, the name of the contact is displayed. Otherwise, only the phone number is displayed.

If more than one phone number is assigned to a contact, only the name of the contact is displayed.

For calls on the additional telephone, the number is only displayed if it is transmitted by the network.

An incoming call to the additional telephone is automatically rejected if there is an active call on the other telephone.

Accepting a call

Via iDrive

"Accept"

Via the button on the steering wheel

Via the button on the steering wheel

Via the instrument cluster Press the button.

Via the instrument cluster

"Accept"

Rejecting a call

Via iDrive

Via the instrument cluster "Reject"

Via the instrument cluster

"Reject"

Ending a call

Via iDrive

"End call"

Via the button on the steering wheel

Via the button on the steering wheel

Via the instrument cluster Press the button.

Via the instrument cluster

"End call"

    See also:

    Vehicle equipment
    All standard, country-specific and optional equipment that is offered in the model series is described in this chapter. Therefore, equipment is also described that is not available in a vehicle, e ...

    Message when the system was not reset
    A Check Control message is displayed. The system detected a wheel change but was not reset. Warnings regarding the current tire inflation pressure are not reliable. Check the tire inflation pre ...

    Storing
    1. Switch on the ignition. 2. Set the desired position. 3. Press the button. The LED in the button lights up. 4. Press the desired button 1 or 2. The LED goes out. If the M button is presse ...