Safety belts

Seats with safety belt

The vehicle has five seats, each of which is equipped with a safety belt.

Number of safety belts

Your vehicle has been fitted with five safety belts for the safety of you and your passengers. However, they can only offer protection when adjusted correctly.

Notes

Always make sure that safety belts are being worn by all occupants before driving away.

Although airbags enhance safety by providing added protection, they are not a substitute for safety belts.

► The shoulder strap's anchorage point will be correct for adult seat occupants of every build if the seat is correctly adjusted.
► The two outer safety belt buckles, integrated into the rear seat, are for passengers sitting on the left and right.
► The center rear seat belt buckle is solely intended for the center passenger.

Never allow more than one person to wear One person per safety belt
Never allow more than one person to wear a single safety belt. Never allow infants or small children to ride on a passenger's lap.◄

Lay the belt, without twisting, snugly Putting on the belt
Lay the belt, without twisting, snugly across the lap and shoulders, as close to the body as possible. Make sure that the belt lies low around the hips in the lap area and does not press on the abdomen. Otherwise, the belt can slip over the hips in the lap area in a frontal impact and injure the abdomen.
The safety belt must not lie across the neck, rub on sharp edges, be routed over solid or breakable objects, or be pinched.◄

Avoid wearing clothing that prevents the Reduction of restraining effect
Avoid wearing clothing that prevents the belt from fitting properly, and pull the shoulder belt periodically to readjust the tension across your lap; otherwise, the retention effect of the safety belt may be reduced.◄

Buckling the belt

Make sure you hear the latch plate engage in the

Make sure you hear the latch plate engage in the belt buckle.

Unbuckling the belt

1. Hold the belt firmly.
2. Press the red button in the belt buckle.
3. Guide the belt back into its reel.

Safety belt reminder for driver's seat and front passenger seat

lights up The indicator lamp flashes or lights up and a signal sounds. Make sure that the safety belts are positioned correctly.

The safety belt reminder is active at speeds above approx. 5 mph/8 km/h. It can also be activated if objects are placed on the front passenger seat.

Damage to safety belts

In the case of strain caused by accidents or damage:

Have the safety belts, including the safety belt tensioners, replaced and have the belt anchors checked.

Have the work performed only by your Checking and replacing safety belts
Have the work performed only by your service center; otherwise, it cannot be ensured that this safety feature will function properly.◄

    See also:

    Starting the engine
    Never use spray fluids to start the engine. 1. Start the engine of the assisting vehicle and let it run for several minutes at an increased idle speed. If the vehicle being started has a diesel ...

    Configuring the warning time
    After the warning function is switched on, the warning time can be set via the iDrive. For a late warning time, prewarning is deactivated. These settings have no effect on the time of the warni ...

    Following the initial pairing
    ▷ The mobile phone is detected/connected in the vehicle within a short period of time when the engine is running or the ignition is switched on. ▷ The phone book entries of the tele ...