Fold-out position of the wipers

Required when changing the wiper blades or under frosty conditions, for example.

1. Switch off the ignition.
2. Under frosty conditions, ensure that the wiper blades are not frozen onto the windshield.
3. Press the wiper lever up beyond the point of resistance and hold it for approx. 3 seconds, until the wiper remains in a nearly vertical position.

After the wipers are folded back down, the wiper system must be reactivated.

Before switching the ignition on, fold the Fold the wipers back down
Before switching the ignition on, fold the wipers back down to the windshield; otherwise, the wipers may become damaged when they are switched on.◀

1. Switch on the ignition.
2. Press the wiper levers down. The wipers move to their resting position and are ready for operation.

    See also:

    Electrically adjustable seats
    At a glance 1 Seat and mirror memory 2 Backrest width 3 Lumbar support 4 Backrest tilt 5 Forward/backward, height, seat tilt Note The seat setting for the driver's seat is stored for the re ...

    Removing: Electrical* head restraints
    Note Do not remove the rear head restraints. To avoid damage, they can only be installed by your service center. Removing Only remove the head restraint if no one will be sitting in the seat ...

    Capturing the image
    The image is captured by two cameras integrated in the exterior mirrors and by the backup camera. The range equals: approx. 10 ft/3 m to the side. approx. 7 ft/2 m to the rear. In this w ...