The concept

This system can replace up to three different hand-held transmitters for various types of remote- controlled equipment, such as garage doors or lighting systems.

The hand-held transmitter signal can be programmed on one of the three memory buttons.

The corresponding device can then be operated using the programmed memory button.

The LED indicates that a signal is being transmitted.

When selling the vehicle, delete the stored programs for security reasons.

During programming and before activating During programming
During programming and before activating a device using the integrated universal remote control, ensure that there are no people, animals or objects in the range of movement of the remote-controlled device; otherwise, there is a risk of injury or damage.

Also follow the safety instructions of the handheld transmitter.◀

    See also:

    After a power failure
    Only put the parking brake into operation after a power failure The parking brake should only be put into operation again if it was manually released due to an interruption in the supply of el ...

    Front
    Seat heating The temperature setting progresses one step through its control sequence each time you press the button. The maximum temperature is reached when three LEDs are lit. To switch of ...

    Tire damage
    General information Inspect your tires often for damage, foreign objects lodged in the tread, and tread wear. Notes Indications of tire damage or other vehicle defects: Unusual vibrations dur ...